TRANSFER BOX
20
OVERHAUL
High/low cross shaft and housing
1. Check mating surfaces of cross shaft and
drilling in housing for wear.
2. Check core plug in housing for signs of
leakage or corrosion, apply Loctite 326 to
replacement plug.
3. Check high/low selector finger for wear.
4. Measure across widest portion of finger:
Finger width = 15.90 to 15.95 mm (0.625 to
0.627 in)
Front output housing and differential lock
selector
1. Check bearing track recesses in housing for
damage, rectify or replace housing as
necessary.
2. Check differential lock selector finger shaft and
drilling in housing for wear.
3. Check differential lock selector finger for wear.
4. Measure across widest portion of finger:
Finger width = 15.90 to 15.95 mm (0.625 to
0.627 in)
5. Check differential lock selector finger groove
width in differential lock selector shaft:
Groove width = 16.0 to 16.1 mm (0.63 to 0.64
in)