TRANSFER BOX
OVERHAUL 3
NOTE: Discovery cover plate illustrated.
19. Make suitable alignment marks between cover
plate/power take-off cover, mainshaft input
gear bearing housing and main casing
20. Noting fitted position of stud nut and
harness/speedometer cable clip, remove 5
bolts and stud nut securing cover plate/ power
take-off cover, recover clip.
21. Remove cover plate/power take-off cover.
22.
Up to serial no. 288709E:
Remove and discard
gasket.
23. Remove oil feed plate - if fitted, remove and
discard ’O’ ring.
24. Remove 2 countersunk screws - if fitted
securing mainshaft input gear bearing housing.
25.
Up to serial no. 288709E:
Remove mainshaft
input gear bearing housing, remove and
discard gasket.
CAUTION: Do not remove mainshaft input
gear bearing track at this stage.
26.
From serial no. 288709E:
Remove mainshaft
input gear bearing housing.
CAUTION: Do not remove mainshaft input
gear bearing track at this stage.