Filter
Top Products
TRANSFER BOX
38
OVERHAUL
High/low cross shaft housing
1. Lubricate cross shaft and new ’O’ ring with
recommended oil.
2. Insert cross shaft into housing, position
high/low selector finger on shaft.
3. Fit ’O’ ring to shaft, locate end of shaft in
hollow plug.
4. Slide ’O’ ring to end of shaft.
5. Align hole in high/low selector finger with
recess in cross shaft.
6. Apply Loctite 290 to threads of setscrew, fit
and tighten screw.
7. Apply Hylomar PL32 sealant to threads of
neutral warning lamp switch - Range Rover
Classic only - if fitted. Fit switch, do not tighten
locknut until switch has been adjusted.
NOTE: Switch must be adjusted after
transfer box is installed in vehicle.
Differential lock selector
1. Lubricate new ’O’ rings with recommended oil,
fit to selector finger shaft and housing.
2. Insert selector finger shaft into housing.
3. Fit selector lever ensuring that relative
positions of lever and finger are as shown.
4. Fit washer and new self-locking nut, tighten nut
to 15 Nm (11 lbf.ft).