Filter
Top Products
TRANSFER BOX
OVERHAUL 33
Mainshaft input gear assembly
1. Lubricate new bearings with recommended oil.
2. Secure hand press LRT-99-002 in a vice.
3. Position collars LRT-41-003 in hand press.
4. Position new bearing on collars.
NOTE: Smallest diameter of bearing must
be towards collars.
5. Locate end of mainshaft in bearing, press
mainshaft through bearing.
6. Repeat above procedure for remaining
bearing.
Intermediate gears.
1. Lubricate new bearings and bearing tracks with
recommended oil.
2. Fit new circlips into intermediate gears.
CAUTION: Ensure that circlips are
correctly seated.
3. Fit new bearing tracks using tools LRT-41-006
and LRT-99-003.
CAUTION: Ensure bearing tracks are fully
seated against circlips.
4. Retain bearings with intermediate gears.