Filter
Top Products
INFO:
. Even after setting a destination, the location
of the destination can be adj usted, the
location can be stored, etc.
“Procedures after setting destination”
(page 5-2)
. The stored route includes only locations
(destination and waypoints) and route cal-
culation conditions, not the route itself.
Therefore, when the destination is set using
a stored route, a different route may be
suggested if the current vehicle location is
different from the one when the route was
stored.
SETTING BY PHONE NUMBER
If the telephone number of the facility is
available, use this to find the facility by entering
the number, and then have the system calculate
a route.
INFO:
. Telephone numbers that were stored for
stored destinations can also be used.
. If the area code of the specified telephone
number does not exist in the map data, the
system will not search for the location.
. Only the locations included in the database
in the map data can be searched by the
phone number. Residential phone numbers
cannot be used to search for a location.
1. Push <DEST>.
2. Highlight [Next Page] and push <ENTER>.
3. Highlight [Phone Number] and push
<ENTER>. The telephone number input
screen is displayed.
4. Enter the telephone number including the
area code.
5. After finishing the entry, highlight [List] and
push <ENTER>.
“Number input screen” (page 2-12)
6. Displays a list screen if there are two or
more search results. Highlight the preferred
destination from the list and push
<ENTER>.
A confirmation screen for the place name
and the location is displayed, and the system
starts calculating.
Setting destination 4-15