Filter
Top Products
8
Step 2) Setting up the Maintenance Tools
Set up the application of this
Maintenance Tools. Please read the guide shown on the screen carefully
to proceed the setting up.
(1) Starting the setup program
1) Start MntToolE.EXE.
Execute “MntToolE.EXE” located in
SetUp ¥2_MNTTOOL
folder of CD-ROM.
Double clicking on “MntToolE.EXE” with the explorer
displays “Welcome” screen. Please confirm the caution
shown on the screen before setting up.
2) Confirm the display contents, and select [Next] button.
If no problem was found on the content, click [Next] button.
* To stop setting up, click on [Cancel] button.
(2) Confirming the Installation folder
1) Confirm the installation folder and select [Next] button.
Confirm the folder on which this program should be installed.
To change the installation folder (C drive only),
Use [Browse] button. After confirming the installation
folder, click on [Next] button.
* Clicking on [Cancel] button stops installation procedure.
(3) Confirming the installation start
1) Confirm the starting and select [Next] button.
Clicking on [Next] button starts installation.
* Clicking on [Cancel] button stops installation.
(4) During installation, a command prompt like the one shown
on the right appears as the process is performed.
Setup may take up to three minutes to complete.
Caution:
During Database setting, the process may be observed as stopped for a while. However, it is still unde
r
operation internally. Wait for some time until "Press any key to continue - - - -" appears without doing anything.
*Do not stop the set up procedure by pressing
at the upper right of the screen.