Filter
Top Products
16
(3) Initial setting of modem
For the modem to be installed at the local side (MN Converter side), initial setting should be applied
before connecting remotely. To apply the initial setting of the modem, click on the
remote setting screen.
The Connection Modem Initial Setting Screen will appear. A modem that is already initialized does
not have to be re-initialized.
The explanation of the operation only is described here. For the detail of the setting content, see
Installation Manual-annexing of MN Converter (CMS-MNF).
(a) Explanation of screen
-Select a registered modem setup file at the Select
Initial Settings File Box. The contents of the selected
file will be listed below the selection box.
-Click on and the modem will be set up
according to the contents selected at the selection
box.
(AT commands are sent to the modem.)
Check if transfer with the modem is normal at the
Transfer with Modem Status Screen.
- Click on to initialize another modem.
Send the initialize command and register the transfer
contents for the modem at the AT Command
Transmit Screen. [Refer to (b)]
- Click on to delete the selected modem
settings from the registered settings. When the
number of registrations limit is exceeded, delete the unwanted contents. [Refer to (b)]
- Click on to return to the Connection Setting Screen.
(b) Perform new modem setup.
- Enter the command (you want to set) you want to send
to the modem at the AT command input text.
Then click on to send the entered AT
command to the modem. The response from the
modem will appear below the entered AT command.
Check the contents.
- After transmission to the modem is complete, click
on . The contents sent to the modem will be
registered as an initialize file. (Registered in the setup
file list of the Connection Modem Initial Setting
Screen.) At this time, do not forget to enter the registration name. Up to ten items can be
registered. If ten items are already registered, new items cannot be registered. Delete unwanted
items using the Connection Modem Initial Setting Screen.
- Click on to return to the Connection Modem Initial Setting Screen.