Filter
Top Products
66
3.12.6 Changing the error notification settings
(1) Click [Option] in the menu bar and
select [Error notification mode] ->
[Error notification mode setting/cancellation]
in the sub-menu.
(2) The information set in the MN Converter is loaded
and the Error notification mode
setting/cancellation screen appears.
Units set on the MN Converter as targets for
error monitoring are marked with an asterisk (*).
(3) Change the desired items in the Error notification
mode setting/cancellation screen.
To change the units targeted for error monitoring,
you have to run the Connection status monitor.
Click [Connection status monitor] to collect the
connection information.
A confirmation window is displayed.
Click [Yes].
Connection status monitor begins.
NOTE:
If you change the units targeted for error monitoring or change the MN Converter address, the MN
Converter will be reset by the change. This will erase the previous error data stored on the MN
Converter.
When the data is erased, notification also stops and no error report log is kept.
To retain the error data, set the Minimum reporting period in the Option settings to 0 minutes before
sending the settings to forcibly report the error data currently stored on the MN Converter.
You can check whether there is currently error data stored on the MN Converter by the STATUS LED,
which will blink at 0.5-second intervals if there is data stored.
For details, see section 3.12.10 "MN Converter LED display" (pattern 4).