Filter
Top Products
67
(4) Select System information settings.
(5) Click [Send settings].
A confirmation window is displayed.
Click [Yes].
Setting begins.
(6) If you change the units targeted for error monitoring or change the MN Converter address, the message
shown below appears.
The MN Converter is reset by the change. This erases the previous error data stored on the MN
Converter. Reporting also stops and no error report log is kept.
Set the “Minimum reporting period” in the Option settings to 0 minutes before sending the settings to
forcibly report the error data currently stored on the MN Converter,
and click [Yes].
Setting begins.
(7) The Settings have been sent message appears and setting
is completed. Click [OK].
(8) If you add the units targeted for error monitoring, the message shown below appears.
Click [OK].