Filter
Top Products
51
3.12 Remote error notification
The “Remote error notification" has been located starting from Ver4.20.
* Items Performed Here
- The MN Converter (CMS-MNG-E) has a built-in remote error notification function.
When an error occurs in an air conditioning unit, the remote error notification function allows previously
registered destinations to be automatically notified of the error via telephone lines.
To use the remote error notification function in the MN Converter (CMS-MNG-E), you must first specify
the remote error notification settings from the Maintenance Tool.
The MN Converter (CMS-MNG-E) has the following 2 modes:
(1) Maintenance mode
In this mode, the MN Converter can only be used as a normal converter.
(2) Remote error notification mode
This mode allows both the normal MN Converter functions and the remote error notification
function to be used.
Use the Maintenance Tool to switch between these 2 modes.
To use the remote error notification function, connect the MN Converter (CMS-MNG-E) to a modem via the
RS-232C port and then connect the modem to the telephone outlet, as shown in the figure below.
For details, refer to the Installation Manual of MN Converter (CMS-MNG-E).
The dedicated server software or other dedicated software tools run on the remote monitoring PC.
To specify the remote error notification function settings using the Maintenance Tool, connect the MN
Converter (CMS-MNG-E) to the Maintenance Tools PC via USB, as shown in the figure below.
M-NET
RS-232C
straight
RS-232C
MN Converter
(CMS-MNG-E)
Remote monitoring PC
(Runs dedicated server software
or other dedicated software tools.)
MODEM
MODEM
Public
network
MN Converter
(CMS-MNG-E)
USB
M-NET
Maintenance
Tools PC
RS-232C
straight
RS-232C
Remote monitoring PC
(Runs dedicated server
software or other
dedicated software
tools.
)
MODEM
MODEM
Public
network
NOTE:
• When setting remote error notification, connect to the MN Converter via USB.