Filter
Top Products
69
(3) When setting is completed, the All settings have been cancelled
message appears.
Click [OK].
The MN Converter switches to maintenance mode, and
the message below appears.Click [OK].
(4) Click [Close] to close the Error notification mode setting/cancellation screen.
3.12.8 Option settings
Use the procedure below to specify the settings for remote error notification mode.
(1) Click [Option] in the menu bar and
select [Error notification mode] ->
[Option setting] in the sub-menu.
(2) The Option setting screen appears.
(3) Change the settings as desired and click [Transmission].
NOTE:
If you selected "Connection with host SC", you must delete the address of the MN Converter from
the connection data for the corresponding unit on the host SC.
NOTE:
After cancellation, check the start/stop condition of the unit for confirmation