Filter
Top Products
11
1.3.3 Uninstalling the Maintenance Tools
The method to uninstall the application of the [Maintenance Tools] once installed is given below.
(1) Uninstalling the Maintenance Tools
1) Confirm the ending of Maintenance Tools.
Confirm that Maintenance Tools program has been ended.
If not, end the program.
*For the ending method, refer to Chapter 1.4.5.
2) Start [Add/Remove Programs].
Click on [Add/Remove Programs] from [Control panel] to
start.
3) Select [Maintenance Tool for windows 2000 and XP]
and press [Change & Remove] button.
Select [Maintenance Tool for windows 2000 and XP] from the application, and click on [Remove]
button.
The deletion of Maintenance Tools application starts.
4) Ending the [Add/Remove Programs].
After ending the deletion of application, end [Add/Remove Programs].
1.3.4 Change of computer name on PC
Do not change the computer name after the Maintenance Tool has been setup.
Maintenance Tool will not run properly if changed, and may require the OS to be installed again.
1.3.5 USB Serial driver installation
To connect the Maintenance Tool to the MN Converter (CMS-MNG-E) via USB and then use the tool, the
USB serial driver must be installed on the Maintenance Tool PC.
(1) Connect a USB cable to the USB port of the MN
Converter (CMS-MNG-E).
A window appears asking you to install the driver.
Select [Install from a list or specific location
(Advanced)] and then click [Next].
NOTE:
•Recommend not to delete the common components.
•There are folders and files that can not be deleted with this uninstalling.
(Example:C:¥Program files¥Mnttool32)