Filter
Top Products
X
Select Daylight Savings Time
(Summer) or Standard Time.
The dot # in front of a list entry indicates
the current setting.
X
Saving setting and exit the menu: Slide
XVY.
Adjusting time lags
i
In some exceptional cases, e.g. where
time zones border, the displayed time and
the local time may show a time lag.
This time lag can be adjusted in steps of 30
minutes.
X
Select Vehicle Q System Q Time Q
Time.
X
Selecting hour or minutes: Slide XVY.
X
Setting value: Rotate cVd or slide ZVÆ.
X
Saving setting: Press W.
Setting the date
X
Select Vehicle Q System Q Time Q
Date.
X
Selecting month, day, or year: Slide
XVY.
X
Setting value: Rotate cVd or slide ZVÆ.
X
Saving setting: Press W.
i
Setting the date is only necessary or even
possible if the COMAND system does not
receive a GPS signal.
Setting the time/date format
X
Select Vehicle Q System Q Time Q
Format.
The format list appears. The dots # in
front of the list entries indicate the current
setting.
X
Changing format setting: Select desired
format.
X
Saving setting and exit the menu: Slide
XVY.
Voice Control System settings
Switching help window on or off
X
Select Vehicle Q System Q Voice
Control.
X
Select Help Window.
A checkmark appears when the help
window is switched on.
Individualization
Using individualization, you can fine-tune the
Voice Control System to your own voice and
thus improve voice recognition. The ability of
the system to recognize the commands of
other users does not deteriorate as a result.
Individualization consists of two parts. You
train the system to recognize digits in the first
part and specific commands in the second
part.
Starting new individualization
i
The vehicle must be stationary to start
individualization. After starting the session,
acoustic instructions will guide you through
the individualization.
X
Select Vehicle Q System Q Voice
Control Q Start New
Individualization.
A prompt appears asking whether you
would like further information.
X
Select Yes or No.
If you select No, the first part of
individualization begins.
If you select Yes, an information display will
be shown with audio instruction.
X
Closing display: Select OK.
The first part of individualization begins.
At the end of the first part, you will see a
prompt asking whether you want to begin
the second part.
X
Select Yes or No.
If you select No, individualization will be
canceled. The data from the first part is
saved automatically.
COMAND system settings
93
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 93
Z