Filter
Top Products
X
Enter the activation code and confirm by
pressing !.
Installation of the map software starts.
When you enter an invalid activation code,
you are prompted to reenter the activation
code. After entering an invalid activation code
for the third time, the prompt for reentering
the activation code will be delayed. The delay
increases by 5 minutes each time an invalid
activation code is entered to a maximum
delay of 5 hours.
Map software installation
Immediately before installation, the
COMAND system reboots.
A corresponding message and a progress bar
appear during the installation process.
X
Canceling installation on the DVD
changer: Press the respective magazine
tray button.
X
Remove the DVD from the slot.
i
When you cancel the installation, the
navigation system will be inoperative. You
can resume a canceled installation at a
later time.
X
Installation of multiple DVD map
software: After installation of the first
DVD, a message appears that prompts you
to insert the next DVD. Follow the
instructions on the COMAND display.
X
Continue installation without
canceling: Let the installation continue
without pressing any buttons.
When the installation has been completed,
a corresponding message appears.
X
Confirming message: Press W.
The DVD is ejected.
X
Remove the DVD from the slot.
The installation is finished.
When the installation has been completed
successfully, a corresponding message
appears.
X
Confirming message: Press W.
The DVD is ejected.
X
Remove the DVD from the slot.
If the installation was unsuccessful:
R
The DVD is dirty or scratched.
X
Clean the DVD (Y page 179).
X
Start the installation of the map
software once more.
R
The system may be overheated due to
excessive temperature in the vehicle
interior.
X
Wait until the vehicle interior has
cooled.
X
Start the installation of the map
software once more.
R
If these measures do not solve the problem:
X
Contact an authorized Mercedes-Benz
Center.
General notes
Operational readiness of the navigation
system following a system software
update by an authorized Mercedes-
Benz Center
After a system software update by an
authorized Mercedes-Benz Center, the
installed map software may no longer be
98
COMAND navigation (introduction)
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 98