Filter
Top Products
Starting the dialog with the Voice
Control System
X
Switch on the ignition (Y page 284).
X
Press button ? on the multifunction
steering wheel.
An acoustic signal sounds. The dialog is
started.
X
Speak a command.
Pausing and resuming a dialog
Pausing
You can pause the dialog when a selection list
is displayed in COMAND.
X
Speak the command “Pause”.
Continue With Push-to-talk appears
at the top of the selection list. You can
select an entry using the COMAND
controller.
Resuming
X
Press button ? on the multifunction
steering wheel.
The dialog is resumed.
Aborting dialog
X
Press button % on the multifunction
steering wheel.
or
X
Speak one of the commands “Stop”, “Quit”,
“Abort”, “Terminate”, “Cancel” or “Exit”.
This does not apply when entering voice
names or during the individualization
process.
or
X
Press any COMAND button.
Setting volume level
X
Activate the Voice Control System.
X
Speak a command, for example “Help”.
X
Press button W or X. The volume is
increased or decreased during voice
output.
or
X
Set volume for voice output using the
COMAND volume thumbwheel on the lower
part of the front center console
(Y page 88).
i
You can also set the text reader speed
(Y page 91).
Displays
COMAND Display
In addition to the acoustic help function, a
visual help function (Y page 93) is available
on COMAND display :.
Upon activating the Voice Control System,
the most important available commands for
the currently active mode appear on
COMAND display :.
When the Voice Control System requires
additional information from the user, a
selection list is shown on COMAND
display : in the address book and navigation
system.
Voice Control System introduction
239
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 239
Z