Filter
Top Products
R
Restaurant
R
Other
With the option Other you can enter stopover
destinations from the destination memory,
last selected destinations, POIs, or via the
address (Y page 123).
You can enter stopover destinations on the
route or in the vicinity of the route.
You can use the stopover function to
influence the route guidance calculation to
the main destination. When you have reached
your stopover, COMAND automatically
calculates the route to the main destination.
Entering predefined destinations
X
Select Navi Q Destination Q
Stopover.
If a stopover has already been entered, you
can change it.
Changing: Select Change Stopover.
You can now select a category.
X
Selecting a category: Select category,
e.g. Gas station.
COMAND first looks for destinations along
the vehicle’s route and within the immediate
vicinity of the vehicle. If there are no
destinations available there, COMAND
searches for destinations in an area around
the vehicle position.
If COMAND does not find any destinations,
you will see a message to this effect.
X
Select OK.
You can now select a different category.
If COMAND finds destinations, you will see a
list of the destinations and details of how far
away they are in the right-hand side of the
display. The information about how far away
the destinations are can take a few seconds
to be displayed.
The left-hand part of the display shows the
destinations on the map. The destination
marked in the list is highlighted in the map.
X
Selecting a destination: Select the
desired destination from list.
The address of the destination appears.
X
Starting route calculation: Select Start,
see also (Y page 120).
Entering another destination as a
stopover
X
Select Navi Q Destination Q
Stopover.
X
Entering: Select Other.
You can select between the following menu
items:
R
Address Entry
R
From Memory
R
From Last Destinations
R
From POIs
X
Select a menu item.
Subsequent destination entries may differ,
depending on your selection:
R
Address Entry selection:
X
Enter a destination by address
(Y page 107).
R
From Memory selection:
X
Enter a destination from the
destination memory (Y page 120).
R
From Last Destinations selection:
X
Enter a destination from the list of last
destinations (Y page 122).
R
From POIs selection:
X
Enter a point of interest (POI)
(Y page 124).
X
Starting route calculation: After entering
a destination, select Start (Y page 120).
Changing a stopover
If a stopover has already been entered, you
can change it.
COMAND navigation system (entering a destination)
123
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 123
Z