Filter
Top Products
i
In predictive speller :, you can only
select currently selectable characters.
Which characters are included depends on
the sequence in which you have entered
your destination and the content of the
destination memory.
While the characters are being selected as
described below, the top list entry always
shows the destination which best matches to
the input data as it has been entered up to
that point.
At the same time, COMAND automatically
adds matching characters to characters
already entered by the user.
X
Changing language for the predictive
speller: Select B.
X
Select desired language.
X
Changing character set for the
predictive speller: Select C.
Depending on the previous setting, you will
change to letters with special characters or
to numbers with special characters.
X
Selecting characters: Slide XVY or
rotate cVd.
X
Confirming character selection:
Press W.
X
Deleting individual characters: Select
F in the bottom line and press W.
X
Deleting an entire entry: Select F in the
bottom line and press W and hold until the
entire entry is deleted.
X
Canceling an entry: Select % in the
bottom line and press W.
or
X
Press back button % in the center
console (Y page 87).
As soon as COMAND can clearly attribute the
characters entered to a destination,
predictive speller : disappears. You see the
destination memory list without predictive
speller. Here you can confirm the current
entry or make another selection.
You can also manually switch to the
destination memory list without predictive
speller at any time.
X
Switching manually to the destination
memory list without predictive speller:
Slide ZV.
or
X
Select ¬ in the second line from the
bottom and press W.
Destination memory list without
predictive speller
X
Selecting a destination: Slide ZVÆ or
rotate cVd.
X
Canceling selection: Press back button
% in the center console (Y page 87).
or
X
Select Back and press W.
i
The Back menu item is only present if this
list was called up from the list with
predictive speller.
X
Confirming selection: Press W.
X
Starting route calculation: Select Start,
see also (Y page 120).
COMAND navigation system (entering a destination)
121
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 121
Z