Filter
Top Products
R
3-D sound does not work for mono-signal
sources, such as on analog AM radio or
in Weather Band.
R
In the event of poor radio reception
quality, e.g. inside a tunnel, you should
switch off Logic 7
®
, as a dynamic switch
from Stereo to Mono could occur,
resulting in temporary sound distortion.
R
With some stereo recordings, the
resulting sound may deviate from
conventional stereo playback.
Switching the audio/video source off/
on
i
When you load a CD or DVD, the audio or
video source is activated automatically.
Active audio source
X
Switching off: Select Audio Q Audio
OFF.
Playback is paused and the audio source is
switched off; Audio OFF appears in the
COMAND display.
X
Switching on: Select Audio, then the
desired audio source.
or
X
Load a CD/DVD (Y page 179) or an SD
card (Y page 180).
or
X
Connect a USB storage device
(Y page 80) or media interface device
(Y page 200) to COMAND.
Active video source
X
Switching off: Select Video Q Video
OFF.
The audio source is switched off; Video
OFF appears in the COMAND display.
X
Switching on: Select Video, then the
desired video source.
or
X
Load a DVD (Y page 179).
SPLITVIEW
SPLITVIEW enables the driver and front
passenger to use separate COMAND
functions at the same time. Two different
displays appear in the COMAND screen. For
example, a Navigation display is only viewable
form the driver’s seat while a DVD Video
display is only viewable from the front
passenger’s seat.
COMAND is operated via SPLITVIEW from the
front passenger seat using the SPLITVIEW
remote control and the special wireless,
infrared headphone. You may also use a wired
headphone via the 3.5 mm socket in the front
passenger footwell.
For information about using the remote
control, see (Y page 81).
For information about using the headphone,
see (Y page 82).
Depending on the production date of your
vehicle, it may be equipped with SPLITVIEW.
At the time of this printing, the use of
SPLITVIEW is NOT allowed in the following US
states (AL, AZ, CO, IL, LA, MA, MD, NH, PA,
VA, VT, WA, WI, and WV) or Canadian
provinces (Manitoba, Newfoundland, New
Brunswick, and Prince Edward Island).
SPLITVIEW must NOT be operated in these
states or provinces. The driver is responsible
for observing ALL local statutory provisions.
If your vehicle is registered in a non-approved
state or province, then the feature will need
to be deactivated. Contact your authorized
Mercedes-Benz dealer to verify if SPLITVIEW
is allowed in your state or province.
Notes
R
The audio volume of the wireless
headphone for the front passenger side
must be adjusted on the headphone
directly. The audio volume of a wired
headphone can be adjusted via the remote
90
COMAND introduction
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 90