Filter
Top Products
X
Press button a again if you would like
to change the current status.
Depending on the previous status, the
Daytime Running Lamps will be switched
on (Enabled) or off (Disabled).
With Daytime Running Lamps mode
Enabled selected and the exterior lamp
switch at position $ or c, the low-
beam headlamps are switched on when the
engine is running.
In low ambient light conditions the following
lamps will come on additionally:
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
For more information on the daytime running
lamp mode, see “Lighting” (Y page 299).
i
Make sure the exterior lamp switch is set
to M or c when you switch off the
daytime running lamps while driving at
night.
Setting Adaptive Highbeam Assist
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Adapt. High-beam Ass. .
X
Press button a.
X
Press button a again if you would like
to change the current status.
Depending on the previous status, the
Adaptive Highbeam Assist will be
Enabled or Disabled.
For more information on the Adaptive
Highbeam Assist, see (Y page 301).
Showing or hiding additional
speedometer
You can have an additional digital
speedometer shown in the multifunction
display. Depending on the setting for the
speedometer display mode (Y page 235), the
speed is shown in the unit of kilometers/hour
(setting miles) or miles/hour (setting km).
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Add. Speedometer function.
X
Press button a.
X
Press button a again if you would like
to change the current status.
Depending on the previous status, the
Add. Speedometer will be switched On or
Off.
Selecting speedometer display mode
X
Press button = or ; to select the
Settings menu.
X
Press button : or 9 to select the
Units function.
X
Press button a.
Instrument cluster control system
235
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 235
Z