Filter
Top Products
Sample dialog:
\
Save destination.
^
Please say the name.
\
John Smith.
^
Please repeat the name.
\
John Smith.
^
Where do you want to save: home or
work?
\
Work.
^
The destination has been saved.
“Find address”
Use the command “Find address” to call up
an address from memory and to start route
guidance.
“Navigate (to) <voice name>” (address
book)
Use the command “Navigate (to) <voice
name>” to start route guidance by selecting
voice name with a saved destination address
from the COMAND address book.
A voice name may have two different
destination addresses associated with it
(home or work).
The system confirms your command,
calculates the route, and begins route
guidance. If only one address is stored, you
can use the command “Navigate (to) <voice
name>” to select the stored destination
address for that name.
If two addresses are stored, you can use the
commands
R
“Navigate (to) <voice name> home”
or
R
“Navigate (to) <voice name> work”
to directly select between home or work
address for that name. The system
confirms your selection, calculates the
route, and begins route guidance.
i
You can also navigate to address book
entries without voice names.
Speak the command “Navigate (to)” and
the first and last name in any order. This
applies to other functions of address book
entries also.
Sample dialog:
\
Navigate to John Smith.
If more than one address exists for this
voice name, the Voice Control System
will prompt you:
^
Navigate to home or work?
\
Work.
^
John Smith work.
Starting route guidance.
“Start route guidance”
Use the command “Start route guidance” to
start route guidance after entering a valid
destination.
Sample dialog:
\
Start route guidance.
^
Starting route guidance.
Route guidance begins.
“Route Information”
You can use the “Route Information”
command to get the following information on
your currently planned route read out:
R
Distance to destination
R
Remaining driving time
R
Expected arrival time
“Guidance instructions on”
Use the command “Guidance instructions on”
to enable the system’s guidance voice output.
The Voice Control System repeats the current
guidance instructions.
“Guidance instructions off”
Use the command “Guidance instructions
off” to mute the system’s guidance voice
output.
Voice Control System navigation
243
Control systems
221_AKB; 6; 20, en-US
d2ugruen, Version: 2.11.8.1
2009-09-24T13:28:17+02:00 - Seite 243
Z