Filter
Top Products
G3X Installation Manual – Appendix B Page B-19
190-01115-01 Revision A
B.4 Circular Connector Installation Instructions
B.4.1 Pigtail Installation Parts
Table B-9 provides a list of parts needed to install a circular connector with backshell. Parts for this
installation are included in the pigtail connector kits and some are to be provided by the OEM/installer.
Table B-9. Parts supplied for a Circular Connector Installation (Figure B-15)
Figure Ref Description GPN or MIL spec
2 Contacts 336-00022-00
3
Circular Backshell Non-Magnetic (includes 2 self-tapping
screws and circular connector)
330-90005-01
Table B-10. Parts NOT supplied for a Circular Connector Installation (Figure B-15)
Figure Ref Description GPN or MIL spec
1 Circular Connector, 19 CKT MS3474L14-19SW
4
Multiple Conductor Shielded Cable (2 conductor
shown in Figure B-15)
Reference Installation Wiring
Diagrams
5 Drain Wire Shield Termination (method optional)
Parts used depend on method
chosen
6
Braid, Flat (19-20 AWG equivalent, tinned
plated copper strands 36 AWG, Circular Mil
Area 1000 -1300)
Parts used depend on method
chosen
7 Floating Shield Termination (method optional)
Parts used depend on method
chosen
Ring terminal, #6, insulated, 18-22 AWG MS25036-102
Ring terminal, #6, insulated, 14-16 AWG MS25036-107
8
Ring terminal, #6, insulated, 10-12 AWG MS25036-111