Garmin GTP 59 GPS Receiver User Manual


 
G3X Installation Manual – Installation Overview Page 1-5
190-01115-01 Revision A
1.5 Installation Requirements
One GDU 37X assembly (listed in Table 1-1) is required, dependent upon customer’s desired database
region. Each GDU 37X (010-00667-XX) comes with all equipment needed for installation.
1.5.1 Required Accessories
The following kits are required for the installation of the G3X.
Table 1-5. Contents of G3X Installation Kit (K10-00017-00)
Item Garmin P/N Quantity
GMU 44, Connector Kit 011-00871-00 1
Config Module w/EEPROM, Jackscrew 011-00979-20 1
Config Module w/Sockets, Jackscrew 011-00979-22 1
Thermocouple Kit 011-00981-00 1
GSU 73, Connector Kit, P9731 011-01818-00 1
GSU 73, Connector Kit, P9732 011-01818-01 1
G3X, Supplemental Parts 011-02347-00 1
GMU 44, Install Rack, Modified 115-00481-10 1
Table 1-6. Contents of G3X LRU Kit (K10-00016-00)
Item Garmin P/N Quantity
GMU 44, Unit Only 010-00296-10 1
GSU 73, Unit Only 010-00691-00 1
GTP 59, Unit Only 011-00978-00 1
1.6 Mounting
Refer to Section 2 through Section 6 for specific mounting instructions for each component of the G3X,
and to Appendix A for Outline & Installation Drawings.
1.7 Wiring/Cabling Considerations
Use MIL-W-22759/16 (or other approved wire) AWG #24 or larger wire for all connections unless
otherwise specified. The supplied standard pin contacts are compatible with up to AWG #22 wire. In
cases where some installations have more than one LRU sharing a common circuit breaker, sizing and
wire gauge is based on aircraft circuit breaker layout, length of wiring, current draw on units, and internal
unit protection characteristics. Do not attempt to combine more than one unit on the same circuit breaker.
RG400 or RG142 coaxial cable with 50 Ω nominal impedance and meeting applicable aviation
regulations should be used for the installation.