Filter
Top Products
80
(1) Transmission status
(2) Reason for transmission interruption
Item Description
In Data Link The data link is being performed.
Suspend Data link (Other) Another station stops the cyclic transmission.
Suspend Data link (Host) The host station stops the cyclic transmission.
Baton Pass (No area) The B/W transmission range of the host station is not assigned.
Baton Pass (Parameter Halt) The parameter of the host station is faulty.
Baton Pass (No Receive) The common parameters have not been received.
Disconnecting (No Baton) The station numbers are overlapped or the cable is not connected.
Disconnecting (Link Error) The cable is not connected.
In Test The online test or offline test is being performed.
Resetting A hardware failure may have occurred.
Item Description
Normal Data communications are being performed normally.
Offline The module is in the offline status.
Offline Test The offline test is being performed.
Initial state
The module is in the initial state (error code: F101, F102, F105).
( Page 88, Section 7.4)
Shift Control Station
An error (error code: F104, F106) has occurred.
( Page 88, Section 7.4)
Online testing
The online test is being performed (error code: F103, F109, F10A).
( Page 88, Section 7.4)
Baton disappearance
An error (error code: F107) has occurred.
( Page 88, Section 7.4)
Baton repetition
An error (error code: F108) has occurred.
( Page 88, Section 7.4)
Same Station Present
An error (error code: F10B) has occurred.
( Page 88, Section 7.4)
Control station repetition
An error (error code: F10C) has occurred.
( Page 88, Section 7.4)
Reception retry error
An error (error code: F10E) has occurred.
( Page 88, Section 7.4)
Transmission retry error
An error (error code: F10F) has occurred.
( Page 88, Section 7.4)
Timeout error
An error (error code: F110) has occurred.
( Page 88, Section 7.4)
Network Disorder
An error (error code: F112) has occurred.
( Page 88, Section 7.4)
Disconnecting...
An error (error code: F11B) has occurred.
( Page 88, Section 7.4)
No baton to local station
An error (error code: F11F) has occurred.
( Page 88, Section 7.4)
Error code:****
An error has occurred.
When an error code is displayed, refer to the error code list and take the corrective action.
( Page 88, Section 7.4)