Filter
Top Products
To mark your present position:
1. Hold down the ENTER/MARK key until the ‘New Waypoint’ window appears then release the key.
The window shows a default three-digit waypoint name/number (001), symbol (dot), and position.
You can leave the name as the auto-assigned number, but for this exercise, lets change the name to
‘DOCK’.
2. Use the ARROW KEYPAD to highlight the waypoint name field (001) and press
ENTER. You see
that just the first ‘0’ is now highlighted.
3. Press LEFT on the ARROW KEYPAD to clear the name field.
4. Press UP or DOWN on of the ARROW KEYPAD until the letter ‘D’ appears, and then press RIGHT
to go to the next space to the right, then UP or DOWN again until ‘O’ appears. Repeat this until
you have entered the name ‘DOCK’. If you make a mistake and select an incorrect character, simply
press LEFT on the ARROW KEYPAD to backspace the cursor and then UP or DOWN to correct the
entry. (If you accidentally press
ENTER before you are done, simply press ENTER again and move
the highlight to where you left off.)
5. After you have entered all the letters, press
ENTER to confirm the name.
6. To access the waypoint symbol page, highlight the waypoint symbol field which is to the left of the
waypoint’s name and press
ENTER. Note: The default symbol is a dot.
7. You see a grid of available waypoint symbols to choose from. Use the ARROW
KEYPAD to high-
light the ‘ANCHOR’ symbol.
8. Press
ENTER to confirm the ‘ANCHOR’ symbol.
9. Highlight ‘OK’ at the bottom of the window and press
ENTER again to confirm the ‘OK’ prompt
and save the waypoint.
The waypoint is now stored in memory. Note that waypoints may also be created graphically from
the map display or by manually entering position coordinates. Each of these techniques is described in
thes reference section of this manual.
Press ENTER/MARK
after entering the name.
You can choose from a list of useful symbols.
There are two Diver Down waypoint
symbols to select from: the International and
U.S. versions.
10
Getting Started
Marking Waypoints