Filter
Top Products
To enable Remote Command:
1. Press the MENU key twice to access the Main
Menu.
2. Cursor to the Setup Menu option and press
ENTER.
3. Tab over to the System Setup Page then cursor
down to the padlock icon above the Remote
Command field.
4. If the icon is locked, highlight it and press
ENTER to pop up the Security window. Enter
your Lock Code to open the lock. If the icon is
not locked then cursor to the Remote Com-
mand field and press ENTER to enable or dis-
able this feature.
To “Query” for a GPS location:
1. Dial the number of a NavTalk unit or similarly
programmed cellular device. When the called
number answer press MENU and cursor to
Query Location and press ENTER. You will
hear the DTMF tones and the Transferring
Location message will appear.
2. When the DTMF tone has been recognized the
other unit will transmit the GPS location to your
unit, but only if it has the Remote Command
feature enabled. If it is not, the tones will stop
and the new position will not be acknowledged.
If the call is disconnected before the transfer is
complete, the new position will not be acknowl-
edged.
3. The new position is acknowledged by a confir-
mation message and the location marked as a
Phone waypoint on the Map Page. Refer to
Page 59 for more information.
5.12 Setting the Call Timers
Call Timers are useful for recording the
time of the last call you made, the elapsed time
of all calls for a measured time period, and the
total lifetime use of your NavTalk call time. You
can also set the NavTalk to signal each time a
minute of your current call has elapsed.
Cell Phone
Reference
SECTION 5
Minute Timer will emit two
beeps each minute unless
turned Off.
54
NavTlkOM.qxd 2/1/00 2:46 PM Page 64