Filter
Top Products
24
Basic Phone
Operation
SECTION 3
3.1 Placing a Call
To place a call:
1. Manually enter the phone number from any page using the
dialing keypad and press
SEND
. The call timer starts count-
ing after you place the call. Or...
2. From the PhoneBook Page highlight the name or number
you want dialed and press
SEND
. The call timer starts
counting after you place the call. Press
PAGE
or
QUIT
to
access the PhoneBook Page. Or...
3. If the number is stored on the Speed Dial Page simply press
the Phone Keypad number that corresponds to the phone
numbers placed on the Speed Dial list. Hold the key down
for more than 1 second to dial that number from any display
on the NavTalk.
3.2 Answering a Call
To answer a call:
1. Press
SEND
. An incoming call is indicated by a ringing tone,
and the CallPress SEND message flashing on the dis-
play. The call timer starts counting.
NOTE: If a call is not answered, the
CallPress SEND
message
will continue flashing and the ringing
tone will continue until
SEND
is pressed. Press-
ing END will mute the ringer for this call.
3.3 Unsuccessful Call Attempts
If you hear one of the following signals, you have
not successfully completed your call:
• Fast Busy
-
The cellular system is busy. To cor-
rect, press SEND again after ending the call, to
immediately redial the call, or press END and dial
the number later.
• Alternating high/low tone -The cellular system
could not complete the call. You may have tried
to place a call before the NavTalk was fully opera-
tive or poor signal strength is preventing the cel-
luar system from receiving the NavTalk signal. To
correct, press SEND to immediately redial the call,
or press END and dial the number again.
• Busy signal - The called party’s phone is busy.
NOTE: When placing a call, wait for the IN USE icon
and phone call should connect. If a connection
cannot be made, fail tones will sound.
Call Notification
Manual Dialing Page
Cellular Status Display
When Redialing a Phone
Number
NavTlkOM.qxd 2/1/00 2:45 PM Page 34