Filter
Top Products
10. MAINTENANCE & TROUBLESHOOTING
10-6
10.5.4 Serial ports
You can confirm the signal input.
1. Rotate the [ENTER] knob to choose Serial port from the SYSTEM TEST.
2. Push the [ENTER] knob to show the Serial port window.
Change parameters
Input data display
Serial port
3. Rotate the [ENTER] knob to choose “Change parameters” and then push the
[ENTER] knob.
Port: PORT2
Baud Rate: 4800
Data Bits: 8
Parity: none
Stop Bits: 1
4. Enter the settings for the port in use and then push the [CLEAR] key.
5. Rotate the [ENTER] knob to choose “Input data display” and then push the
[ENTER] knob.
6. Press the [CLEAR] key twice to finish.
Note: When choosing Input data display, the data input from the external
equipment connected are shown.
10.6 Program No.
You can confirm the software program No by following procedure.
1. Rotate the [ENTER] knob to choose “ADVANCED”, and then push the
[ENTER] knob.
2. Rotate the [ENTER] knob to choose “SYSTEM UPDATE”, and then push the
[ENTER] knob to show the System update menu..
System Update
Plotter SW version: 1451721-**.**
SW Development No: 10.06.***
Kernel: 1.03.***
NTSL: 6.01.***
BIOS: 1.02.***
File System: 3.00.***
Worldwide Charts *.**
GPS: 485026****
*: Program version No.
Update Plotter Software
Update Worldwide Maps
3. To escape from the System update menu, press the [MENU] key.