Filter
Top Products
6. NAVIGATION
6-5
6.3 Following a Route
You can follow a route as follows.
Setting a complete route as destination
This method enables you to navigate from the first waypoint of a route.
1. Press the cursor pad to place the cursor at the location not occupied by
waypoint.
2. Press the [TLL/GOTO] key to show the GO TO window.
3. Rotate the [ENTER] knob to choose ROUTE and then push the [ENTER]
knob to show the SELECT ROUTE window.
1 0001RT
2 0002RT
3 0003RT
4 __________
5 __________
6 __________
7 __________
8 __________
9 __________
10 __________
SELECT ROUTE
ROUTE NAME
Select route window
4. Rotate the [ENTER] knob to choose a route which you want to set as
destination.
5. Push the [ENTER] knob.
Setting part of a route as destination
You can start the route navigation from any waypoint in a route.
1. Open the route list.
2. Press the cursor pad (▲▼) to choose the route desired.
3. Rotate the [ENTER] knob to choose PLOT at the bottom of the screen, and
then push the [ENTER] knob.
The plotter display appears.
4. Press the cursor pad to place the cursor on any waypoint which is part of the
route you want to set as destination.
5. Press the [TLL/GOTO] key.
A line runs between destination selected and own ship’s position. Also, range
and bearing from own ship’s position to destination appear in the data window.
You can change the destination in the route by pressing the PREV or NEXT soft
key.