Filter
Top Products
68 Split shroud security seals
Section 3: Electrical installation Daniel 3812 Liquid Ultrasonic Flow Meter Installation Manual
March 2013 3-9000-765 Rev D
3.7.6 Split shroud security seals
Use the following instructions to install the security seal wires on the split shroud covering the
meter body and transducer assemblies.
Figure 3-14 Split shroud security seals
Procedure
1. Install the security seal wire into and through the holes in the split shroud clamp bent
tab and the upper split shroud bent tab. (maximum wire diameter .078 inch; 2.0 mm).
2. Remove all slack and seal.
3. Cut wire ends to remove excess wire.
4. Repeat these steps for the other split shroud clamps.
5. This completes the split shroud security seal installation procedure.
A.
A. Upper split shroud
B. Split shroud clamp
C.
D
B
C. Security wire seals
D. Lower split shroud