Filter
Top Products
58 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
Zoom Menu
This menu is invoked by pressing the ZOOM button. The default zoom amount is 100%. By selecting Amount and
pressing SEL the user may increase zoom above 100% (zoom into the input Video) or decrease zoom below 100%
(zoom out). Independent zoom values are maintained for each input channel.
A View (certain zoom and pan settings) associated with the currently selected input channel may be saved from this
menu. After the desired zoom setting is selected use the encoder knob to scroll to Save View and press SEL. The
current zoom setting will be saved. This View will be restored on power up for the corresponding input channel. The
user may also change/save the View Pan settings for the currently selected input channel from the Pan Menu. Recall
view allows the user to recall the saved view for the selected input channel.
Pan Menu
This menu is invoked by pressing the PAN button.
There are four selections available for panning, as shown in the menu diagram. The values range from -100% to
+100%. 0% pan means that the center of the input image coincides with the center of the output image for the given
pan direction. For vertical pan, an increasing value moves the image downward. For horizontal pan, an increasing
value moves the image to the right. The screen will be properly updated when SEL is pressed in any selection line.
Independent pan (and zoom) values are maintained for each input channel.
A View (certain zoom and pan settings) associated with the currently selected input channel may also be saved from
this menu. After the desired pan settings are selected use the encoder knob to scroll to Save View and press SEL.
The current pan settings will be saved. This View will be restored on power up for the corresponding input channel.
The user may also change/save the Zoom settings for the currently selected input channel from the Zoom Menu.
Recall view allows the user to recall the saved view for the selected input channel.
Pan and Zoom Reset
Pressing and holding the PAN and ZOOM buttons simultaneously will restore the pan values to 0% and zoom value
to 100% for the currently selected input channel.
ZOOM
> Amount <val>
Save View
Recall View
PAN
> Horizontal <hVal>
Vertical <vVal>
Diag \ <h/vVal>
Diag / <h/vVal>
Save View
Recall View