Filter
Top Products
42 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
When Input Auto Acquire is On, the system will always perform a full sync acquisition on the input signal anytime the
input channel is selected, the input type is changed, or the input signal changes sync rates.
When Auto Acquire is Off, the system will use the last known configuration for each input channel, to the greatest
extent possible. At some point, the input signal may be too far away from the saved configuration, in which case a
good input lock may not be possible. If the input signal is too different from the saved configuration to be usable, then
the <in_format> field in the Status Display will read “Invalid Signal”.
NOTE: It is recommended that In Auto Acquire is left on for most users. The ImagePRO™ will automatically
detect and acquire the input video type and resolution in most cases and limit menu selections as applicable
to the detected Video type. Advance users that know the input video timing parameters may choose to turn
In Auto Acquire off and select them manually. In Auto Acquire must be turned off in switching applications
where the user already configured and saved the unit’s input setup. Turning auto acquisition off will provide
the fastest transition times for switching applications. When auto-acquisition is on the transition time will be
greater due to the additional time required to analyze the input video timing.