Filter
Top Products
Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
21
Operation
ImagePRO™ can be controlled by using the front panel menu controls or remotely via RS-232 or Ethernet interface.
The front panel menu controls are described in detail in this section. Remote control commands are described in
detail in section 4.
ImagePRO™ Front Panel Controls
CR E RAE S H
ADJUST
SEL
ESC
TEST
SETUP
PAN
PAT
ZOOM
MENU KEYS
1
INPUTS
2 3
BLACK
FREEZE
Figure 3-1 ImagePRO™ Front Panel
SEL
Used to select a menu option, control setting, or configuration change.
ESC
Current operation in progress is cancelled. Control returns to the previous menu or the system status display. Any
changes made within a control function are undone.
SETUP, TEST PAT, ZOOM, PAN
These four buttons allow entry into the menu system. Pressing any of these four buttons causes that button to light
up, and the display goes to the top-level of that particular menu system. Pressing the button again darkens the
button and changes the display to the Status Display mode. Pressing a different menu button will cause the system
to immediately switch to the new menu. The test pattern light also acts as an indicator that a test pattern is on.
1, 2, 3
The input source buttons are used to select the input, which will be routed to the output using the transition type
specified in the Effects menu.
BLACK
The Black button can be thought of as an additional input video source. When selected the Black button LED will be
lit and the output will be black. The Black input can be de-selected by selecting one of the other three input sources.
When Black Input is selected the Status Display indicates “INTERNAL BLACK” as the input format and the Pan and
Zoom buttons are not operational.
FREEZE
Turns the Freeze feature on or off. When turned on the Led will be illuminated. Allows a displayed image to be
temporarily frozen. When Freeze is selected the Pan and Zoom buttons are not operational and the Input Setup and
View menus are inaccessible since these adjustments cannot be applied to a frozen image. If another input is
selected Freeze will be turned off.