Filter
Top Products
Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
37
Output Setup Submenu
This menu is used to configure the outputs of the ImagePRO. The Output Setup Menu is illustrated below. This menu
can be accessed from the SETUP MENU.
NOTE:
Configuration parameters entered in this menu are saved in non-volatile memory by using the SAVE CONFIG
menu item. If the SAVE CONFIG menu item is not selected, the information will not be restored upon the next
system power up sequence. If the user performed changes and did not save them the following message will
be displayed upon exiting the Output menu by pressing ESC, SETUP, PAN, TEST PAT and ZOOM.
The user may select Yes to save the changes or No to continue operation without saving the changes. If the
user exits the Output setup menu by selecting another input any changes made will not be saved in non-
volatile memory.
[Output Format]
The user may select the desired Output format from a list of standard formats as well as custom format saved by the
user. Note that the unit’s outputs are not updated until the SEL button is pressed.
NOTE: The Digital Cinema Projector resolutions at 2048x1080p@59.94Hz
and 2048x1080p@60Hz are only
supported on the ImagePRO-SDI and ImagePRO-HD.
Timing Adjust Submenu
The Timing Adjust sub-menu allows the user to make adjustments to the currently selected output format timing
parameters. This menu is illustrated below.
OUTPUT
[out_format]
> Timing Adjust >>
Comp/S-Vid Adj >>
Sync Settings >>
Underscan <val>
Colorspace <val>
Gamma <val>
Sharpness <val>
Flicker Reduce <val>
Genlock >>
Save Config
Reset Config
Save Output Cfg?
<SEL> = Yes
<ESC> = No