Filter
Top Products
40 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
Flicker Reduce
The Flicker Reduce value is n/a when the output format is non-interlaced. For interlaced formats, the range is Off
(no flicker reduction) or +1 (minimum flicker reduction) through +20 (maximum flicker reduction).
Genlock Submenu
This sub-menu sets up the genlock operation:
Source
Source selects the genlock source from among the following:
Freerun
Input Video (Genlock source is the currently selected input Video)
H+V Sync (Lock source are external H & V sync pulses)
Csync (Lock source is an external Composite sync input)
Blk Burst (Genlock source is an external Black Burst Signal)
Genlock Type Submenu
This sub-menu allows the user to selects the different types of genlock:
Type selects the genlock mode. The selections depend on the selected genlock source and possibly the input/output
configurations. If the source is Freerun, the type is n/a. The available types are:
V Lock (Vertical lock only)
HV Lock (Both Horizontal and Vertical lock)
HVSc Lock (Full genlock)
Type V is available for all genlock sources.
Type HV is available for all sources, but only if the input and output V Totals are the same.
Type HVSc is only available when the output format is PAL or NTSC. The source must be the Black Burst external
genlock source or Input Video. As in the HV type, the V total of the source must equal the V total of the output
format.
When Genlock type HVSc is selected, the message “FOR COMPOSITE OUT” is displayed as shown below:
GENLOCK
> Source [val]
Type >>
H Phase <val>
SC Phase <val>
GENLOCK TYPE
> Type [val]