Filter
Top Products
Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
29
<in_format>
Indicates the current input video format in the form, Hact x Vact @ Vr Hz (i.e 1024x768@75
Hz). If the currently
selected input channel and source do not have a valid input signal, the <in_format> field will display “Invalid Signal”.
When In Auto Acquire is on the input video format will be detected in the following search order: last used
configuration for the selected input channel, any saved input configurations, custom library formats
created by the user, standard library formats or best guessed to the closest video format in library. If the
video format is best guessed it will be displayed enclosed within asterisks in the Status Display. (i.e
*1024x768@60.11*
). If the video format is recalled from a saved input configuration, a ‘c’ character is
displayed as the right most character. (i.e. 1024x768@59.94 c).
When Auto Acquire is off the ImagePRO
™ will attempt to lock to the signal with the input video format
selected by the user. If the currently selected format does not match the input signal for the selected
channel the display will remain black and the Status Display will indicate “Invalid Signal”.
Type selection
Values for this item are: RGB, YPbPr, NTSC/PAL/SECAM, SDI, and DVI.
The type selection allows the user to select among the possible signal types available at the current input channel.
When Auto Acquire is on the type selections will be limited depending on the signal on the currently selected input
channel. For example, if channel 1 of an ImagePRO-HD™ is connected to a DVI source, DVI will be the only choice
and it could not be changed. Also SDI will be the only choice whenever the SDI input is selected on ImagePRO-SDI™
and ImagePRO-HD™.
When Auto Acquire is off the type selections are expanded to allow the user to manually select the Video type.
If a source type is chosen and a correct signal cannot be detected for that source, the <in_format> field in the INPUT
SETUP menu, and in the status display, will indicate Invalid Signal.
YPbPr Colorspace selection
Values for this item are: RGB, SMPTE, BETA, M-II.
INPUT
<in_format>
> Type <type>
ColorSpace [val]
Sampling [val]
Timing Adjust >>
Contrast <val>
Brightness <val>
Color Balance >>
Gamma <val>
Aspect Ratio >>
Letterbox <val>
Processing >>
Save Config >>
Reset Config
Recall Config >>
Delete Config >>