Filter
Top Products
Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
51
System Submenu
This menu allows the user to adjust the VFD Brightness and remote control setting for RS-232 or Ethernet Interfaces
as illustrated below.
NOTE:
Configuration parameters entered in the system menu are saved in non-volatile memory by using the SAVE
SYSTEM STATE menu item. If the SAVE SYSTEM STATE menu item is not selected, the information will not
be restored upon the next system power up sequence. If the user performed changes and did not save them
the following message will be displayed upon exiting the System menu by pressing ESC, SETUP, PAN, TEST
PAT and ZOOM.
The user may select Yes to save the changes or No to continue operation without saving the changes.
VFD Brightness
The VFD Brightness menu selections control the intensity of the front panel vacuum fluorescent display (VFD). The
adjustment range is -7 to 8. -7 is the dimmest setting and 8 is the brightest. The factory default setting is 8.
NOTE:
Whenever possible it is recommend using a low intensity setting to avoid “burn-in” of the display.
RS232 Submenu
The Baud value is selected from the following values: 1200, 2400, 9600, 19200, 38400.
The parameters value is selected from the following values: N81, E71, O71, E72, O72.
SYSTEM
> VFD Brightness <val>
RS232 >>
Ethernet >>
EDID DVI In Frmt >>
Save System State
Save System Cfg?
<SEL> = Yes
<ESC> = No
RS232
> Baud [val]
Parameters [val]
Handshake [val]
Reset