Filter
Top Products
Manual # 26-0302000-00 / Revision E ImagePRO – Multi Format Image Processor
23
ImagePRO-HD™ Front Panel Controls
ADJUST
TEST
SEL
SETUP
ESC
PAN ZOOM
PAT
1 2 3
LOGO
----------
BLACK
MENU KEYS
INPUTS
FREEZE
HSE A RER C
SDI
Figure 3-3 ImagePRO-HD™ Front Panel
SEL
Used to select a menu option, control setting, or configuration change.
ESC
Current operation in progress is cancelled. Control returns to the previous menu or the system status display. Any
changes made within a control function are undone.
SETUP, TEST PAT, ZOOM, PAN
These four buttons allow entry into the menu system. Pressing any of these four buttons causes that button to light
up, and the display goes to the top-level of that particular menu system. Pressing the button again darkens the
button and changes the display to the Status Display mode. Pressing a different menu button will cause the system
to immediately switch to the new menu. The test pattern light also acts as an indicator that a test pattern is on.
1, 2, 3, SDI
The input source buttons are used to select the input, which will be routed to the output using the transition type
specified in the Effects menu.
LOGO / BLACK
The Logo/Black button can be thought of as an additional input video source and allows the operator to capture and
display a stored image. When selected the Logo/Black button LED will be lit and the output will display either a stored
image (typically a company logo) or black.
To capture an image, the operator presses and holds the input source button to select the desired input source and
then presses the Logo/Black button. ImagePRO-HD™ will freeze the output image and capture an output frame from
the selected input source and store the image in non-volatile memory. A progress bar and related messages will be
shown on the VFD display during this capture process to notify the operator that the image is being captured and
saved.
The Logo/Black input can be de-selected by selecting one of the other four input sources. When Logo/Black Input is
selected and no logo is stored, the output will display black and the Status Display indicates “INTERNAL BLACK” as
the input format and the Pan and Zoom buttons are not operational. When Logo/Black Input is selected and there is a
logo stored, the output will display the logo and the Status Display indicates “LOGO” as the input format and the Pan
and Zoom buttons are not operational.
Once an image has been stored, the operator can use the LOGO/BLACK key to select the stored image. If an image
has not been stored, the default image is a black frame.
FREEZE
Turns the Freeze feature on or off. When turned on the LED will be illuminated. Allows a displayed image to be
temporarily frozen. When Freeze is selected the Pan and Zoom buttons are not operational and the Input Setup and
View menus are inaccessible since these adjustments cannot be applied to a frozen image. If another input is
selected Freeze will be turned off.