Filter
Top Products
38 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
For the Horizontal entries, the unit of measure is pixels. H Total indicates the total pixel count per line. H Position sets
the offset of start of active area from H sync. H Active sets the size of the active area. H Sync sets the H sync width.
For the vertical entries, the unit of measure is lines. V Total indicates the total line count per frame. V Position sets
the offset of start of active area from V sync. V Active sets the size of the active area. V sync sets the V sync width.
When the output format is NTSC or PAL, H Total and V Total cannot be changed.
Comp/S-Vid Adjustments Submenu
NOTE:
This sub-menu is not available if the selected output format does not support Composite and S-Video
outputs.
This sub-menu allows adjustments specifically to the output encoder, which produces composite and S-Video outputs
as illustrated below:
Brightness values correspond to a percentage of the output format’s standard brightness level. Adjusting this up or
down will cause the output encoder to shift the Y (luminance) value correspondingly. The range is 100% to 114%,
with 100% being nominal.
Contrast values correspond to a percentage of the output format’s standard contrast level. The range for this is
limited to 75.0% to 125.0%, with 100.0% being nominal. Steps are 0.1%.
Hue is n/a if the output format is PAL. For NTSC, the Hue is measured in degrees, and is adjustable from -22.0 to
+22.0 degrees. Steps are in 0.1 degree increments.
Saturation values are given as a percentage of the output format’s standard saturation level. The range for this is
limited to 75.0% to 125.0%, with 100.0% being nominal. Steps are 0.1%.
Pedestal is used to enable or disable the 7.5 IRE pedestal on NTSC output. Turn the knob to highlight On or Off and
press SEL. The default is On for NTSC. This control is not available for PAL. When PAL is selected, pedestal is
disabled.
TIMING ADJUST
> H Total [val]
H Position [val]
H Active [val]
H Sync [val]
V Total [val]
V Position [val]
V Active [val]
V Sync [val]
COMP/S-VID ADJ
> Brightness <val>
Contrast <val>
Hue <val>
Saturation <val>
Pedestal <val>