Filter
Top Products
56 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
Save System State
This command explicitly saves all settings in the system state submenu so they may be restored at power up. This
command will also save the currently selected input channel as the default input selection upon power up. If the user
wants the ImagePRO to always power up and acquire and convert an input other than input one, the user must
perform a save system state command while the desired input is selected.
NOTE:
Configuration parameters entered in the system menu are saved in non-volatile memory by using the SAVE
SYSTEM STATE menu item. If the SAVE SYSTEM STATE menu item is not selected, the information will not
be restored upon the next system power up sequence.
Factory Reset
This command allows the user to reset the unit into its “from the factory” condition – deleting all saved user
information, input configurations, custom formats and views. When the command is executed, a confirmation menu
is displayed:
Pressing SEL causes the command to be executed, followed by a complete system reset. Pressing ESC returns to
the "Setup" menu.
NOTE:
Performing a Factory Reset will erase all user saved input configuration files, Views, Custom formats and
restores ImagePRO memory to its “from the factory” condition.
Clear all config,
formats, and views?
<SEL> = Yes
<ESC> = No