Filter
Top Products
26 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
Status Display
After power-up or anytime none of the four menu buttons are selected, the display will show a basic status. This
screen gives information about the currently selected system inputs and outputs. The input section always reflects the
currently selected input channel, as determined by the input buttons. If the input channel is changed, then the input
fields of this screen may change. Most other changes will be caused by menu selections and will therefore become
visible when returning to this display. In this display, the variable fields are as follows:
<type>
Specifies the type of input signal being processed, and is one of NTSC/PAL/SECAM, SDI, HD-SDI, RGB, YPbPr, or
DVI.
<in_format>
Indicates the current input video format in the form, Hact x Vact @ Vr Hz (i.e 1280x1024@60
Hz). If a user input
configuration is used for the current input video, the <in_format> field will show the name of the user input
configuration instead. If the currently selected input channel and source do not have a valid input signal, the
<in_format> field will display “Invalid Signal”.
<genl_mode+src>
Indicates the current genlock mode and source (if locked.) The possible entries for this field are:
Freerun (Not locked. Freerun timing)
HVScLock, Brst (Genlocked to an external Black Burst signal)
HVScLock, InVid (Genlocked to input video)
HV Lock, Csync (Horizontal and Vertical lock to external Composite Sync)
HV Lock, H+V In (Horizontal and Vertical lock to external separate H and V signals)
HV Lock, InVid (Horizontal and Vertical lock to input video)
V Lock, Brst (Vertical lock to external Blacl Burst signal)
V Lock, V In (Vertical lock to external V sync)
V Lock, InVid (Vertical lock to input video)
If the unit is set for a particular genlock mode and source, but that source is missing or lock can not be achieved, then
the unit will automatically revert to freerun mode, the display will change to “No Lock”, and the source field will remain
unchanged.
<out_format>
Indicates the current output video format in the form, Hact x Vact @ Vr Hz (i.e 1920x1080i@59.94
Hz).
Menu Control
The adjustment knob and the SEL and ESC keys are used to navigate through a series of menus displayed on the
VFD display. The menus are used to enter setup parameters. Pressing one of the four hot keys will call up the
corresponding menu on the VFD.
IN: <type>
<in_format>
OUT: <genl_mode+src>
<out_format>