Filter
Top Products
30 ImagePRO – Multi Format Image Processor Manual # 26-0302000-00 / Revision E
The Color space value allows the user to select among the possible Component Video Standards for YPbPr. For all
other video types the color space is RGB and cannot be selected or changed. The default selection for YPbPr is
SMPTE. The user may change this setting to BETA or M-II to allow the ImagePRO™ to correctly sample the Y, Pb
and Pr components across their full dynamic range.
Sampling
Values for this item are: OverSample and 1:1. 1:1 is the default setting.
The Oversample option is only available for RGB and YPbPr analog inputs. All other input types have defined sample
clocks that are inherently 1:1. If the input is set to one of the other types, the value for this selection will be n/a.
Timing Adjust Submenu
This menu allows for exact positioning of the input signal's active area.
There are two forms for this menu, depending on the current sampling mode. For oversampling, the menu is:
When the sample mode is 1:1, the menu is:
Oversampled Timing Edge selections
These four menu items are available only when the Sample Mode is Oversample. They are used to define the exact
locations of the active video edges. For the right and left edges, these values set the edge locations, in pixels, relative
to the start of H Sync. For top and bottom, the values are in lines, relative to the start of V Sync.
NOTE: It is recommended that the user turns on the Output Raster Box on ImagePRO™ when making active
area adjustments. The input image should be adjusted to align with all four edges of the raster box. The
raster box is intentionally “broken” to allow the user to view the input video behind it and align the input
video to the raster box precisely.
OVRSMP TIMING ADJUST
> Right Edge <val>
Left Edge <val>
Top Edge <val>
Bottom Edge <val>
1:1 TIMING ADJUST
> Auto Config
Sample Phase <val>
H Total <val>
H Position <val>
H Active <val>
V Total <val>
V Position <val>
V Active <val>