Filter
Top Products
11
17
STARTER SYSTEM
Fig. 45 – 1.0 Kw (Standard) Fig. 46 – 1.2 Kw (Optional)
IDENTIFICATION NUMBER
IDENTIFICATION NUMBER
28100-87805 28100-87806
STARTER SYSTEM – GENERAL INFORMATION
Two different starter motors are used on Briggs & Stratton Daihatsu diesel engines. The standard motor is rated at 1.0
Kw., Fig. 45. The optional starter is rated at 1.2 Kw., Fig. 46. The starters are identified by their identification numbers.
The starters are similar enough that service procedures and specifications are the same. Where differences occur,
they will be shown.
STARTER CURRENT DRAW TEST – ALL
(Starter Installed)
Important: When making the starter current draw test
make sure that all parasitic load is removed from the
engine and that engine has the correct viscosity oil.
Engine temperature should be at least 21° C (70° F).
Make sure battery and solenoid connections are clean
and tight.
NOTE: Battery voltage must not be below 11.7
volts.
Test Equipment
The following equipment is required to test current
draw of starter, Fig. 47.
1. Digital multimeter, Tool #19464.
2. DC shunt, Tool #19468.
3. Two battery cables with alligator clips.
4. One jumper wire with alligator clips.
5. A fully charged 12 volt battery.
Fig. 47 – Test Equipment
JUMPER
WIRE
BATTERY
CABLES
19390
19468