Filter
Top Products
12
5
LUBRICATION SYSTEM
2. Remove oil pan screws and nuts.
a. Remove oil pan and discard gasket.
b. Remove oil pick-up tube and strainer. Discard
gasket, Fig. 7.
Fig. 7 – Removing Oil Pan
OIL PICK-UP
TUBE
3. Remove bell housing adapter screw if equipped.
and install flywheel holder, Tool #19418.
LEAVE TOOL INSTALLED.
a. Remove crankshaft pulley using Tool # 19420,
Fig. 8.
Fig. 8 – Removing Crankshaft Pulley
FLYWHEEL
HOLDER
4. Remove timing gear cover, Fig. 9.
a. Discard timing gear cover gasket.
Fig. 9 – Removing Timing Gear Cover
5. Remove the following parts, Fig. 10.
a. Camshaft timing gear.
b. Oil pump gear.
c. Injector pump nut.
d. Idler gear.
Fig. 10 – Removing Gears
C
A
D
B