Filter
Top Products
Workman MDE
Page 3 -- 22
Electrical System
Fuses
There are three (3) fuses in the Workman electrical sys-
tem.
Two (2) of the fuses are located beneath the steering
column (Fig. 34). These fuses supply power to the fol-
lowing:
Theupper 10amperefuse (F2)supplies powerto the
on/off switch and switched circuits.
The lower10 amperefuse (F3) suppliespower toop-
tional accessories.
The third fuse (F1) is located under the controller cover
beneath thecargo box(Fig. 35).This fuse is rated at355
amperes continuous and allows current flow between
the batteries and the vehicle. If this fuse has failed, ve-
hicle operation will not occur.
Testing
CAUTION
Whentesting fusesfor continuitywitha multime-
ter (ohms setting), make sure that fuse is re-
moved from circuit.
IMPORTANT: Before removing fuse F1 (355 Amp)
for testing, openthe batterycircuit by removing one
of the battery cables (see Opening Battery Circuit in
the General Information section of this chapter).
Make sure on/off switch is turned OFF. Remove fuse to
check continuity. The test meter should read less than
1 ohm.
If fuse F1 was removed, torque the nuts that secure the
fuse from 45 to 50 in --lb (5.1 to 5.6 N--m).
Figure 34
1. Fuse (F2)
2. Fuse (F3)
1
2
1. Controller
2. Fuse (F1)
3. Main contactor
Figure 35
1
2
3