Filter
Top Products
Workman MDE Page 5 -- 21 Chassis
Removal (Fig. 13)
1. Park vehicle on a level surface, turn on/off switch
OFF, set parking brake and remove key from the on/off
switch.
2. Open the battery circuit by carefully removing one of
the battery cables (see Opening Battery Circuit in the
General Information section of Chapter 3 -- Electrical
System).
3. Remove hood using Figure 13 as a guide.
Installation (Fig. 13)
NOTE: Do nottighten fasteners securing the hooduntil
all fasteners are in place.
1. Install hood using Figure 13 as a guide. During as-
sembly,use fastenertorque specificationsthat areiden-
tified in Figure 13.
2. Reconnect removed battery cable to battery termi-
nals. Install lock washer and nut on battery terminals.
Torque nuts from 115 to 125 in--lb (13.0 to 14.1 N--m).
1. Negative cable to vehicle 2. Positive cable to vehicle
Figure 14
A
4
1
2
Chassis