Filter
Top Products
Workman MDE
Page 3 -- 5
Electrical System
Special Tools
Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The multimeter can test electrical components and cir-
cuits for current, resistance or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt--
Ohm--Amp multimeter when testing electrical circuits.
Thehigh impedance(internalresistance) ofadigital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
NOTE: Workman MDEvehicles use a 48 volt,DC elec-
trical system.If multimeter is notof the auto--range type,
make sure to properly set multimeter range before per-
forming any voltage test.
Figure 3
Battery Terminal Protector
Battery Terminal Protector is an aerosol spray that
should be used on all battery and controller terminals to
reduce corrosion problems. Apply terminal protector af-
ter cable has been secured to terminal.
Toro Part Number: 107--0392
Figure 4
Dielectric Gel
Dielectric gel should be used to prevent corrosion of
connectionterminals.Toensure completecoatingof ter-
minals, liberally apply gel to both component and wire
harness connector, plug connector to component, un-
plug connector, reapply gel to both surfaces and recon-
nect harness connector to component. Connectors
should be thoroughly packed with gel for effective re-
sults.
Toro Part Number: 107--0342
Figure 5
Electrical
System