Filter
Top Products
The Autopilot information bar
The Autopilot information bar is displayed when an autopilot
mode is selected. The bar includes information about the autopilot
mode and navigational information. The bar is present on all pages
if the autopilot is in an active mode. In the Autopilot settings dialog,
you can select that the bar is off when the autopilot is in standby
mode. Refer to the "Autopilot settings" on page 104.
Autopilot control of the trolling motor
Selecting an Arrival mode
The autopilot switches from navigation mode to the selected arrival
mode when your vessel reaches the destination. Arrival mode is set
to Standby by default. Before starting a navigation mode or a turn
pattern, it is important to select an arrival mode that fits your
navigation needs. Refer to "Arrival mode" on page 104.
Anchor mode
Maintains your vessel position at a selected location.
Ú
Note: When in anchor mode, your vessel orientation can be
affected by wind or currents.
Anchor mode
Waypoint Enables anchor mode when your vessel arrives at
a selected waypoint.
Cursor Enables anchor mode when your vessel arrives at
the cursor position.
Here Enables anchor mode at your current location.
Autopilot | HDS Gen3 Operator Manual
99