Filter
Top Products
1. Position at least two routepoints on a new route, or open an
existing route for editing.
2. Select Autorouting, followed by:
- Entire Route if you want the system to add new routepoints
between the first and the last routepoint of the open route.
- Selection if you want to manually select the routepoints that
define the limits for the autorouting, then select the relevant
routepoints. Selected routepoints are colored red. Only two
routepoints can be selected, and the system discards any
routepoints between your selected start and end points.
3. Select Accept to start the automatic routing.
-
When the automatic routing is completed the route appears
in preview mode, and the legs are color coded to indicate
save or unsafe areas. Navionics uses red (unsafe) and green
(safe), while C-MAP uses red (unsafe), yellow (dangerous) and
green (safe).
4. Move any routepoints if required when the route is in preview
mode.
5. Select Keep to accept the routepoints positions.
6. Eventually repeat step 2 (
Selection) and step 3 if you want the
system to automatically position routepoints for other parts of
the route.
7. Select Save to complete the automatic routing and save the
route.
Autorouting and Easy Routing examples
• Entire route option used when first and last route points are
selected.
First and last routepoint Result after automatic routing
54
Waypoints, Routes, and Trails | HDS Gen3 Operator Manual