Filter
Top Products
93iQue
®
3000 Operating Instructions
HOTSYNC > IR HOTSYNC OPERATIONS
5. Click to select the way you want to transfer data, or click Do Nothing to skip data transfer for an application.
6. Choose how long the setting will remain in effect:
• To have the setting affect only the next HotSync
®
operation, deselect Set As Default. Thereafter, the HotSync Actions revert to their
default settings.
• To use a new setting as the default, select the Set As Default option. Thereafter, whatever you selected as the default setting is used
when you click the Default button in the Custom dialog.
7. Click OK.
8. Repeat steps 4 through 7 to change conduit settings for other applications.
9. Click Done to activate your settings.
IR HotSync Operations
Your organizer is equipped with an infrared (IR) port that supports the IrCOMM implementation of the standards for infrared
communication established by the Infrared Data Association (IrDA). This means that you can beam data to any other device that
supports the IrCOMM implementation of the IrDA standards. Most importantly, you can use the IR port to perform HotSync
operations. You do not need a cradle to do this. This is very useful if you travel with an infrared-enabled laptop. You simply enable
infrared communication on your laptop and handheld and follow the steps in “Performing an IR HotSync Operation” later in this
section.
Preparing your Computer for Infrared Communication
Before you can perform a HotSync operation using the IR port, the computer you want to synchronize with must meet the following
requirements:
• The computer must support the IrCOMM implementation of the IrDA standards.
• The computer must have an enabled infrared port built in or an enabled infrared device attached to the computer.
Desktop computers are likely to require an infrared device attached to a physical serial port. Laptops are likely to have a built-in IR
port. Your computer must also have an installed infrared driver.
Check your computer’s documentation to determine if the computer supports infrared communication.
To check if your Windows
®
computer supports infrared communication:
1. Click Start in the Windows taskbar.
2. Choose Settings, and then choose Control Panel.
3. In the Control Panel, look for the infrared icon.
If the icon is there, your computer is enabled for infrared communication. If it is not there, you need to install an infrared driver.
After you install the infrared driver or determine that the infrared driver is already installed, check the ports used by your computer
for infrared communication.