Filter
Top Products
19iQue
®
3000 Operating Instructions
ENTERING DATA > ENTERING DATA USING GRAFFITI® 2 HANDWRITING SOFTWARE
General Guidelines for Graffiti
®
2 Writing
Follow these guidelines to learn and use Graffiti 2 writing strokes successfully:
• To achieve 100% accuracy, practice drawing characters exactly as they appear in the tables later in this chapter.
• The heavy dot in each shape indicates where to start the stroke. Some characters have similar shapes but different starting
and ending points. Always start your stroke at the heavy dot. (Do not draw the heavy dot; it is only a guideline.)
• The Graffiti 2 writing strokes for letters closely resemble letters of the standard English alphabet, both uppercase and
lowercase. Most characters require only a single stroke. When you lift the stylus from the text input area, your handheld
recognizes and displays the text character immediately.
For multi-stroke characters, a temporary character is displayed after the first stroke, to show that the stroke was recognized.
For example, after the first vertical stroke of “t”, a temporary “l” is shown. There is a short time delay, during which you
must draw the second stroke. Otherwise, the temporary stroke is recorded.
• The text input area is divided into two parts, one for writing lowercase letters and one for writing numbers. The small marks
at the top and bottom of the text input area define the division line. To have your handheld recognize letters and numbers,
you must begin letter strokes on the left side and number strokes on the right side of the text input area. Uppercase letters are
formed by writing across the division line.
Write lowercase letters here.
Write uppercase letters across the division line.
Write numbers here.